4-100
FACSIMILEâ–ºOTHERS FUNCTION
ASSUMING A SPECIFIC USAGE
SPECIFYING THE TIME FOR COMMUNICATION
Specify a time at which a transmission or broadcast transmission will automatically take place. Transmission begins
automatically at the specified time.
This function is helpful when you wish to perform reserved, broadcast or other transmissions during your absence or at
night or other times when telephone rates are low. A timer setting can also be specified for polling reception to receive a
fax when you are not present.
• When a timer transmission is set, keep the main power switch " ". Transmission will not take place if the status is " "
at the specified time.
• When performing a timer transmission, you must scan the original into memory when you set up the transmission. It is not
possible to leave the document in the document feeder tray or on the document glass and have it scanned at the reserved
time of transmission.
• Up to 100 timer transmissions can be stored at once.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
• If another transmission is in progress when the specified time arrives, the timer operation will begin after that transmission
is finished.
• Only one timer polling operation can be stored at once. To receive data from multiple destinations by polling, specify Timer
for serial polling.
• Settings selected for a timer transmission (exposure, resolution, other functions, etc.) are automatically cleared after the
transmission is finished. (However, when the document filing function is used, the scanned original and settings are stored
in the built-in hard drive.)
• If a job scheduled for timer transmission is given priority on the job status screen, the timer will be cancelled. The
transmission will begin as soon as the job in progress is completed.
â–º PRIORITY PROCESSING OF A RESERVED JOB
(page 1-89)
• The time can be specified up to a week in advance.
• Other operations can be performed after a timer transmission is set up.
• A timer transmission can be deleted in the job status screen.
1
Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
â–º AUTOMATIC DOCUMENT FEEDER (page 1-82)
â–º DOCUMENT GLASS (page 1-84)
During the day
configure the setting to
transmit data at 20:00.
At 20:00, the
transmission begins
automatically
To Next Page
Loading...
Need help?
General
