7-168
SYSTEM SETTINGSâ–ºSYSTEM SETTINGS
Power ON/OFF Schedule Setting
The machine operator panel can be turned On or Off at a preset time. Up to three (3) patterns can be set. The "Setting
1", "Setting 2" and "Setting 3" are executed in this sequence if set at the same day of week or at the same clock time.
Toner Save Mode
This mode is used to reduce toner consumption.
Toner consumption can be set for each print job of "Copy", "Printer", and "Prints (Document Filing)".
Toner consumption can be selected from three levels.
• Toner Save1 (Toner Consumption: Much)
• Toner Save2 (Toner Consumption: Middle)
• Toner Save3 (Toner Consumption: Little)
• The scheduling function does not support the power management settings in the Preheat Mode and Auto Power Shut-Off
Mode.
• The preset power-off time is subject to the following restrictions:
• If the machine is running due to the current job execution or other reasons, the machine is turned off only after the job has
finished.
• The machine cannot receive printer jobs.
• The machine can receive output jobs, such as received fax data outputs.
• If the Time Specified Output of Received Data setting is enabled, they are output next time the machine is turned on.
• If the power management setting is also enabled, the Power On/Off Scheduling settings precede.
• If the same time is specified, settings are applied in the order of "Setting 1", "Setting 2", and "Setting 3".
• The power is not turned off in the following cases:
• "Power Up Auto Clear" is in progress.
• While the optimization of the hard disk is in progress or while a restart is in progress after the setting mode has been
changed.
• The preset power on/off time is within one minute from when the setting is accepted.
Items may not be displayed depending on country and region.
To Next Page
Loading...
Need help?
General
