7-79
SYSTEM SETTINGSâ–ºUSER CONTROL
Search for a sub code
Enter the sub code and sub code name, then tap the [Search] key; the search result is displayed.
Settings
Card Setting
Card Area Setting
The data check during card reading can be set.
Settings
Card Type / Card Reader Settings
Use these settings for authentication and for use of a HID or other IC card.
Settings
Item Description
Sub Code Enter the sub code. Specify the code using up to 32 single-byte characters.
Sub Code Name
Enter the sub code. Specify the code name using up to 32 double- or single-byte
characters.
Available to
The registered billing codes can only be shared in the specified group.
When not specifying a public destination, select [All Users].
When specifying a public destination, select [Designate Public Address.], then specify a
group to share the billing code.
To register a group for specifying a public destination
In "Settings (administrator)", select [User Control] → [Organization /Group List].
Item Description
Check System Code only in
FeliCa User Area mode
Check the System Code only in FeliCa User Area mode.
Check Facility Code in HID mode
Checks the facility code of a HID card.
Facility Code
Enters the facility code of a HID card. When you tap the [Store] key, the facility code is
stored.
Importing from the setup file
When you enter the configuration file name and tap the [Execute] key, the card area
settings are read from the configuration file. If you tap the [Clear] key, all files that match the
current search conditions are deleted.
Item Description
Card Type / Card Reader Enter the card type and card reader information.
To Next Page
Loading...
Need help?
General
