MX-3114N ADJUSTMENTS AND SETTINGS 5 – 83
2) Enter the adjustment value of TRAIL EDGE (SIDE1/SIDE2)
with 10-key, and press [OK] key.
TRAIL EDGE (SIDE 1):
Rear edge image loss adjustment value (Front surface)
TRAIL EDGE (SIDE 2):
Rear edge image loss adjustment value (Back surface)
(When the adjustment value is increased, the rear edge image
loss is increased.)
(Change for change in the set value: 0.1mm/step)
Perform the procedures of 1) - 2) until a satisfactory result is
obtained.
(Front/rear frame direction image loss adjustment)
1) Make a duplex copy in 100% in the RSPF mode. Check to
confirm that the image losses on the front frame side and the
rear frame side are 2.0 2.0mm on the front surface and the
back surface.
If the above condition is not satisfied, perform the following
procedure.
2) Enter the adjustment value of FRONT/REAR (SIDE 1) /
FRONT/REAR (SIDE 2), and press [OK] key.
FRONT/REAR (SIDE 1):
Front/Rear image loss adjustment value (Front surface)
FRONT/REAR (SIDE 2):
Front/Rear image loss adjustment value (Back surface)
(When the adjustment value is increased, the front/rear image
loss is increased.)
(Change for change in the adjustment value: 0.1mm/step)
Perform the procedures of 1) - 2) until a satisfactory result is
obtained.
ADJ 19 Finisher and punch unit
adjustments (alignment, punch
hole position, staple position)
This adjustment must be performed in the following cases:
* When the finisher is disassembled.
* When the finisher control PWB is replaced.
* When the punch unit is disassembled.
* When the punch control PWB is replaced.
* When the alignment is improper.
* When the punch hole position is shifted.
* When the staple position is shifted.
1) Enter the SIM 3-10 mode.
Paper F
side edge
Paper R
side edge
Copy image
Copy image
Image loss
2.0 2.0mm
Image loss
2.0 2.0mm
To Next Page
Loading...
Need help?
General
