MX-3114N SPECIFICATIONS 2 – 5
(9) Operation panel
(10) Controller board
(11) Memory/Hard disk
23 cpm
26 cpm/31 cpm
*1: Memory capacity for printer controller
*2: HDD capacity depends on procurement and sourcing status.
*3: Require when installing XPS expansion kit (Local purchase)
*4: When installed productivity kit is 4GB
(12) Warm-up time
*1: Result may change depending on conditions.
*2: Conditions: Leave the machine for 60 sec. after door open,
standard condition, Polygon stops.
Size 7 inch
Type Dot matrix LCD, touch panel
Display dot number 800 x 480 dots (WVGA)
LCD back-light LED lamp back-light system
CPU ARM11: 600MHz
ARM9: 400MHz/during 1W energy save mode: 75MHz
PCL accelerator
(Productivity kit
installed)
QorIQ P1013 800MHz
Interface
Ethernet 1port
Interface 10Base-T, 100Base-TX, 1000Base-T
Support
Protocol
TCP/IP (IPv4, IPv6), IPX/SPX, NetBEUI, EtherTalk
USB 2.0 (high
speed) (host)
2port
(Simultaneous use of the front/rear ports is enable.)
USB 2.0 (high
speed) (device)
1port
USB-HUB (host) Internal: 4port
• For Front USB Port
• For Rear USB Port
• For IC Card Reader
• For Key Board
Serial I/F 1port
Memory See the section "Memory/Hard disk".
Memory slot Main unit: On Board
PCL : 1 slot (1 slot: empty)
SD
card
For Image process For Printing *
1
HDD*
2
On Board On Board SLOT
8GB
*4
2GB (STD) 1GB (STD) 2GB (OPT)*3
320GB
(OPT)
SD
card
For Image process For Printing *
1
HDD*
2
On Board On Board SLOT
4GB 2GB (STD) 1GB (STD) 2GB (OPT)*3
320GB
(STD)
SD card
memory
area
Boot/Program area
FAX data
storage
area
23 cpm 26 cpm/ 31
cpm
Without
productivity
kit
512MB
With
productivity
kit
1GB 1GB
Main power SW
Warm-up time
*1
23cpm 19sec
26cpm/31cpm 18sec
Pre heat Yes
Jam recovery time
*2
37sec. or less
To Next Page
Loading...
