Sharp MX-2314N - Transfer Section

MX-3114N MAINTENANCE 9 – 23
E. Transfer section
(1) Primary transfer unit
23 cpm machine
26 cpm/31 cpm machine
Unit
name
Parts work
sequence
Part name
When
calling
100
K
200
K
300
K
400
K
500
K
600
K
700
K
800
K
Remark
Primary
transfer
unit
1 Separation pawl – ✕✕✕✕ ✕✕✕✕Replace as needed.
2 Primary transfer belt – When replacing, apply
KYNAR powder.
3 Secondary drive transmission gear – 
4 Primary transfer belt drive roller – 
5 Primary transfer belt follower roller – 
6 Primary transfer belt tension roller – 
7 Registration backup roller – 
8 Y auxiliary roller – 
9 PTC backup roller – 
10 Primary transfer roller – ✕✕✕✕✕✕✕✕Replace as needed.
11 Transfer cleaner seals F/R – ✕✕✕✕ ✕✕✕✕
12 Primary transfer belt cleaner blade – 
13 Primary transfer toner reception
blade
– ✕✕✕✕✕✕✕✕Replace as needed.
14 Primary transfer operation mode
detector
– 
Unit
name
Parts work
sequence
Part name
When
calling
200
K
300
K
400
K
600
K
800
K
900
K
1000
K
1200
K
Remark
Primary
transfer
unit
1 Separation pawl ✕✕– ✕✕ ✕– ✕✕Replace as needed.
2 Primary transfer belt ✕  –  
– When replacing, apply
KYNAR powder.
3 Secondary drive transmission gear ✕  – – 
4 Primary transfer belt drive roller ✕  – – 
5 Primary transfer belt follower roller ✕  – – 
6 Primary transfer belt tension roller ✕  – – 
7 Registration backup roller ✕  –  – 
8 Y auxiliary roller ✕  – – 
9 PTC backup roller ✕  – – 
10 Primary transfer roller ✕✕– ✕✕✕– ✕✕Replace as needed.
11 Transfer cleaner seals F/R ✕✕– ✕✕ ✕– ✕✕
12 Primary transfer belt cleaner blade ✕  –  – 
13 Primary transfer toner reception
blade
✕✕– ✕✕ ✕– ✕✕Replace as needed.
14 Primary transfer operation mode
detector
✕  –  – 
g Check (Clean, replace, or adjust according to necessity.) Ũ : Clean
Ţ : Replace : Lubricateţ : Adjust ŭ