MX-3114N DISASSEMBLY AND ASSEMBLY 10 – 28
D. Developing section
(1) Developing unit
a. Developer
1) Open the cover, and remove the developing unit.
2) While rotating the gear, dispose of developer.
Thoroughly clean developer unit so that no developer remains
in the unit. Be careful not to scratch the MG roller.
3) Loading developer to the developing units.
Be sure to shake the bag of developer thoroughly before pour-
ing into the developing unit.
When pouring the developer into the unit, use care to not get
developer in to the drive section.
4) Install the cover.
5) Shake the developing unit several times horizontally and
strongly.
6) Open the toner shutter of the developing unit and check to
confirm that there is proper amount of developer. If not, per-
form procedure 5) again.
No. Name
1 Developer
2DV seal
3 DV side seals F/R
4 Toner filter
To Next Page
Loading...
