Sharp MX-2314N - Page 382

MX-3114N DISASSEMBLY AND ASSEMBLY 10 – 36
(2) Primary transfer cleaner unit
a. Transfer cleaner seal F/R
1) Remove the transfer cleaner seal F/R.
When replacing the transfer cleaner seals R/F, attach a new
seal to the reference.
Thoroughly clean the frame surface of any old glue residue
before attaching the new seals.
b. Primary transfer belt cleaner blade
1) Remove the primary transfer belt cleaner blade.
c. Primary transfer toner reception blade
1) Remove the primary transfer toner reception blade.
When replacing the primary transfer toner reception blade,
attach a new one to the reference.
Thoroughly clean the frame surface of any old glue residue
before attaching the new seals.
After replacement of the primary transfer belt, perform the following
procedures.
1) With the primary transfer cleaner unit removed, apply starting
powder (UKOG-0123FCZZ) to the whole surface of the pri-
mary transfer belt.
2) Attach the primary transfer cleaner unit.
3) Manually rotate the transfer belt drive gear to remove starting
powder from the primary transfer belt clearly.
No. Name
1 Transfer cleaner seal F/R
2 Primary transfer belt cleaner blade
3 Primary transfer toner reception blade
1
2
3
1
Blade edge reference 0 - 0.3mm
Frame edge reference 0 - 0.3mm
2
1
1
Frame edge reference 0 - 0.3mm
Frame edge reference
0 - 0.3mm