Sharp MX-2314N - Page 451

MX-3114N OPERATIONAL DESCRIPTIONS 13 – 31
Operation flow
(1) Toner patch electrostatic latent images are formed on the OPC drum.
(2) The toner patch electrostatic latent images are developed and transferred on the primary transfer belt.
(3) Each toner patch density is detected by the toner density sensor.
(4) By comparing with the reference gamma, the correction value is calculated.
(5) The dither data in the actual operation mode are formed in the MFP PWB according to the correction value, and applied to the actual
operation mode.
0#507"
-#$607"
-#GRIDVOLTAGE
$6BIASVOLTAGE
4#07"
$6UNIT
)NMATEDENSITY
SENSORIMAGE
REGISTRATIONSENSOR
4EMPERATURE
HUMIDITYSENSOR
,35
-#UNIT
$,
-&007"
,35MOTHER07"
3#507"
(IGHDENSITYPROCESS
CONTROLDATA
$6BIASVOLTAGE
-#GRIDVOLTAGE
0APERTYPE
0APERSIZE
$UPLEXMODE
/0#DRUMCOUNTER
(4DITHER,54
$6BIAS
VOLTAGE
4RANSFERCURRENT
6IDEODATA
)MAGEDATA
,ASERPOWER
/0#DRUM
0RIMARY
TRANSFERUNIT
3ECONDARY
TRANSFERUNIT
$6MOTOR
,35TEMPERATURE
SENSOR
,35
TEMPERATURE
)MAGEDENSITYLEVEL
(ALFTONEPROCESSCONTROL
DATA$ITHERCORRECTION
4ONER
MOTOR
-#GRID
VOLTAGE
4ONERCARTRIDGE
ROTATIONPHASE
/0#DRUM
4ONERDENSITY
SENSOR
/0#DRUM
ROTATIONSENSOR
,%$CURRENT
CONTROL
4ONERCARTRIDGE
COUNTER
0IXELCOUNTER
4ONERSUPPLY
QUANTITY
#ALCULATIONUNIT
0IXELCOUNTERDATA
,35DISTORTION
CORRECTIONTABLE
,IGHTQUANTITYCONTROL
3TANDARD
REFLECTIONPLATE









