Shimadzu GCMS-QP2010 Series - Checking Column Information

GCMS-QP2010 Series Operation Guide 7
2.4 System Configuration
2
2.4.2 Checking Column Information
Information for the column attached to the instrument must be specified correctly.
Check or change the column information settings after installing a column.
1
Double-click the (Column) icon in [Modules Used for Analysis].
The [Modules of Analytical Line#] window opens.
If the column to be used is not displayed under [Selected Column] area:
1 Click the name of the column to be used in the [Registered Columns] table.
2 Click [Select].
The column information is displayed under [Selected Column].