2 Safety information
2.1 General safety notes
DANGER
T
he product can not offer the expected protection if it is integrated incorrectly.
b
Plan the integration of the product in accordance with the machine requirements
(project planning).
b
Implement the integration of the product in accordance with the project planning.
DANGER
D
eath or severe injury due to electrical voltage and/or an unexpected startup of the
machine
b
Make sure that the machine is (and remains) disconnected from the voltage
supply during mounting and electrical installation.
b
Make sure that the dangerous state of the machine is and remains switched off.
DANGER
Im
proper work on the product
A modified product may not offer the expected protection if it is integrated incorrectly.
b
Apart from the procedures described in this document, do not repair, open, manip‐
ulate or otherwise modify the product.
CAUTION
L
aser class 1
Figure 1: Laser class 1
T
his device has been classified in accordance with the following standards:
•
IEC 60825-1:2007/EN 60825-1:2007
•
IEC 60825-1:2014/EN 60825-1:2014
•
21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser Notice
No. 50 dated 2007-06-24
The laser is eye-safe. Looking directly into the laser may cause temporary impairments.
The outlet opening of the laser radiation is located in the sender, see figure 5,
page 21. The laser is only active when the laser alignment aid is switched on.
Laser identification is located on the rear of the sender.
b
Comply with the latest version of the applicable provisions on laser protection.
SAFETY INFORMATION 2
8021645/1EB0/2022-04-28 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4
9
Subject to change without notice
To Next Page
Loading...
Need help?
General
