SICK deTec4 User Manual

8. Once configuration is complete and the device has been restarted, align the
sender and r
eceiver.
9. Briefly interrupt the voltage supply, then switch it back on.
10. Check alignment.
11. Check the contactors.
Further topics
•
"Pr
oject planning", page 26
•
"Mounting", page 76
•
"Electrical installation", page 86
•
"Configuration", page 91
•
"Mounting the system plug", page 76
•
"Configuration mode", page 95
•
"Configuring the restart interlock", page 103
•
"Factory settings", page 93
•
"Sender and receiver alignment", page 110
•
"Check during commissioning and modifications", page 115
8.3 Switching on
Overview
Af
ter switching on, the sender and receiver initialize. All LEDs on the sender and
receiver will light up briefly. They then indicate the following information:
•
If a change to the configuration is detected or the device has been reset to factory
settings, the device is in configuration mode and the field indicator flashes green
•
The field indicator and diagnostic LEDs indicate the current configuration
•
The receiver indicates the alignment quality using diagnostic LEDs 1, 2, 3 and 4
after a few seconds
Diagnostic LEDs 5 and 6 light up if the topmost beam (far from system plug) is
s
ynchronized. Diagnostic LEDs 7 and 8 light up if the bottommost beam (near
system plug) is synchronized.
•
In nor
mal operation, the diagnostic LEDs indicate the current configuration. The
field indicator, the STATE LED of the sender and the OSSD LED of the receiver also
light up.
Further topics
•
"C
onfiguration mode", page 95
•
"Indications when switching on", page 124
8.4 Sender and receiver alignment
Overview
Onc
e mounting and electrical installation are complete, the sender and receiver must
be aligned with each other.
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during the alignment process.
b
Make sure that the outputs of the safety light curtain do not affect the machine
during the alignment process.
8 COMMISSIONING
110
O P E R A T I N G I N S T R U C T I O N S | deTec4 8021645/1EB0/2022-04-28 | SICK
Subject to change without notice

SICK deTec4 Specifications

General

Brand	SICK
Model	deTec4
Category	Safety Equipment
Language	English