Pin Wire color
1)
s S
ender r Receiver
6 Pink In1
(laser alignment aid
switch/cascade synchroni‐
zation input)
OSSD2 (output signal
switching device 2)
7 Blue 0 V DC (voltage supply
in
put)
0 V DC (voltage supply
input)
8 Red MFP1
(Single system or host:
sender/receiver communi‐
cation)
MFP1
(Single system or host:
sender/receiver communi‐
cation)
1)
Applies to the extension cables recommended as accessories.
Table 25: System connection pin assignment for SP2 system plug (M12 male connector, 8-pin)
PIN Wire color
1)
r R
eceiver
1 White In3
RES (reset pushbutton
input) or override (override
input)
2 Brown +24 V DC (voltage supply
in
put)
3 Green MFP3
ADO (application diagnostic
output)
4 Yellow In4
EDM (EDM in
put) or muting
signal 1
5 Gray OSSD1 (switching output 1)
6 Pink OSSD2 (output signal
s
witching device 2)
7 Blue 0 V DC (voltage supply
input)
8 Red MFP1
(S
ingle system or host:
sender/receiver communi‐
cation)
1)
Applies to the connecting cables recommended as accessories.
Further topics
•
"Int
egration in electrical control", page 54
6.4 Extension connection (M12, 5-pin)
Pin assignment at the extension connection
Figure 53: Extension connection (female connector M12, 5-pin)
ELECTRICAL INSTALLATION 6
8021645/1EB0/2022-04-28 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4
89
Subject to change without notice
To Next Page
Loading...
