How to fix corrupt parameters on SICK GM35 Measuring Instruments?
If the SICK Measuring Instruments displays ‘Display output: Corrupt Parameters: Reset Memory’, press Enter to perform a system restart, which resets the parameters to the factory settings. If necessary, reconfigure individual parameters. If the error message reappears, replace the control unit, or contact SICK Service.
What to do if SICK Measuring Instruments displays CD: P No Signal SLV?
If your SICK Measuring Instruments displays 'CD: P No Signal SLV', check the connection and line connections of the pressure sensor on the purge air attachment and repair if necessary.
What to do if SICK Measuring Instruments displays El too hot SLV?
If your SICK Measuring Instruments displays 'El too hot SLV', improve the cooling of the sender/receiver unit.
Why does SICK GM35 display Air purge low SLV?
If your SICK Measuring Instruments shows 'Air purge low SLV', check the purge air supply (blower, hoses) and change the filter on the purge air blower if necessary. Consult the Purge Air Supply Manual for further instructions.
What causes corrosion on the flange of SICK Measuring Instruments?
If you observe corrosion on the flange of your SICK Measuring Instruments, check the project planning to ensure suitable materials are being used.
What to do if the evaluation unit is not responding on SICK Measuring Instruments?
If the evaluation unit of your SICK Measuring Instruments isn't responding, begin by checking the power supply to all system components. Ensure the power supply is available on-site and verify/reconnect all connections on the system components. Also, check the operating voltage set on the evaluation unit and adjust if necessary. Inspect the fuse in the evaluation unit and replace it if it's defective. If the issue persists, disconnect all system components from the power supply and reconnect them one at a time, checking the CAN bus cable from the evaluation unit to the SR-unit or terminal box. If the error continues, replace the last connected component and contact service. Also, check the 24V/5V supply and replace the evaluation unit or electronic board module if defective, and contact se...
General| Brand | SICK |
|---|---|
| Model | GM35 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
