SIEB & MEYER SD2M - Endat 2.1 with Sine Signals (1 Vpp)

8.7.4 EnDat 2.1 with Sine Signals (1 V
pp
)
NOTICE
Voltage (VCC) varies depending on the set measuring system
When the connected measuring system is operated under a wrong voltage, it can be
damaged.
→ Check that you have chosen the right measuring system in the software before
connecting.
Fig. 34: EnDat 2.1 with sine signals
Fig. 34: EnDat 2.1 with sine signals
When this meysuring system is parameterized VCC_FB is switched to 5.3 V.
71Drive System SD2M - Hardware Description 036228xxF
Connection Examples