Parameterization
9.3 Parameterization via the powerconfig software
3KC ATC6500 transfer control device
Manual, 05/2019, L1V30538268002A-01
159
9.3.2 Parameterization via the front interface
1. Attach the front interface adapter to the ATC6500.
2. Connect the supplied USB connecting cable (length 1.5 m) to the adapter and to your PC.
3. Launch the powerconfig software.
4. Parameterize the device.
Further information on the subject of powerconfig can be found on the Internet.
By means of the USB front interface, the device can be parameterized without the need for a
cutout in the cabinet door. This is electrically isolated from the circuit of the ATC6500.
Note
Software required
In order to parameterize the device using the USB front interface, you require the
powerconfig software, version 3.12 or higher.
To Next Page
Loading...
