Parameterization
9.2 Changing the parameters
3KC ATC6500 transfer control device
158 Manual, 05/2019, L1V30538268002A-01
9.2 Changing the parameters
● The parameters can be changed using the ◄ and ► keys.
● Pressing the ◄ and ► keys simultaneously restores the factory setting.
● For a text string entry, the character is selected using the ▲ and ▼ keys and the cursor is
moved through the text using the ◄ and ► keys.
● By pressing the ✓ key, the currently selected parameter is stored. The device then
returns to the menu one level above this (see example of submenu P04 Battery in
chapter Parameterization via the user interface (Page 155)).
Note
Restart after parameter change
After each parameter change the device executes a restart. If it remains in the setup menu
for more than two minutes without any changes being made, the device will also restart.
After the restart, the ATC is in the OFF mode.
Note
Saving parameters
Only those parameters that can be changed via the keypad are able to be stored in the
backup memory of the device. Via the Commands menu (see chapter
Table of commands
72)) the current parameters can be saved with the C15 command and the stored
parameters can be loaded from the backup memory with the C16 command.
9.3 Parameterization via the powerconfig software
9.3.1 Procedure for parameterization via powerconfig
In order to parameterize the device using the powerconfig software, the existing RS485
interface COM1 can be used.
In addition, the following optional accessories can be used:
● USB front interface 3KC9000-8TL73
● With the expansion module for communication 3KC9000-8TL75 (Ethernet).
To Next Page
Loading...
