Product description
4.6 Navigation through the main menu
3KC ATC6500 transfer control device
38 Manual, 05/2019, L1V30538268002A-01
4.6 Navigation through the main menu
Press ► and ◄ or ▲ and ▼ to scroll through the main menu functions in a clockwise / counter-
clockwise direction. The selected symbol is highlighted, and the description of the function is
shown in the center of the display.
The selected function can then be activated by pressing the ✓ key.
4.7 Display pages of the ATC6500
4.7.1 Description of the display pages
Some of the display pages listed below may possibly not be available if the function has
been deactivated. Likewise, additional display pages can be displayed if supplementary
functions are activated, e.g. user limit thresholds. Some of the following display pages can
only be viewed via the main menu; you can scroll freely between the remaining pages.
The following display pages are available on the ATC6500:
Overview
Name of the corresponding source (can be set by means of parameter P06.n.01)
Symbol that defines the source as a generator
Voltage unit: Select either V or kV (in this case, voltage of Source 2)
Symbol that defines the type of load (NPL is displayed in the case of non-prioritized loads)
Status and name of the tie breaker
Status and name of the circuit breaker of Source 1
Priority setting of the source: I has the highest priority (can be changed via P06.n.02)
Average voltage of the source (in this case of Source 1)
Symbol that defines the source as a network
Designation of the transfer switching equipment (can be set via P01.10)
In the Overview submenu you can view the current voltage and frequency of the sources. It
also shows which of the two switching devices is activated. The symbols for generator and
To Next Page
Loading...
