Siemens SENTRON ATC6500 - Enabling Additional Resources

Functions
5.1 Basic functions
3KC ATC6500 transfer control device
Manual, 05/2019, L1V30538268002A-01
57
5.1.4.1 Enabling additional resources
The expansion modules provide additional resources that can be used via the corresponding
Setup menus.
Note
Availability during physical absence of modules
The Setup menus for the expansions ar
e also available if the modules are not physically
present, i.e. the inputs 9
-20 on the device can be parameterized, even though no module is
inserted,
and these inputs are therefore not available. As it is possible to add several
modules of the same type
(for example, two communication interfaces), several of the
corresponding Setup menus are available and are identified by consecutive numbering.
The table below shows how many modules of each type can be installed simultaneously and
in which slots they may be used. There must be no more than three modules.
Module type
Order number
Function
Maximum number
that can be inserted
Communication
3KC9000-8TL75
Ethernet (MODBUS TCP)
1
Digital inputs
and outputs
3KC9000-8TL60
4 digital inputs
2
3KC9000-8TL61
4 digital outputs, SSR* (4 NO contacts)
2
3KC9000-8TL62
2 digital inputs and 2 digital outputs, SSR* (2 NO contacts)
2
3KC9000-8TL63
2 digital relay outputs (2 changeover contacts)
2
3KC9000-8TL64
2 digital inputs and 2 relay outputs (2 NO contacts)
2
* Solid state relay