3. Label the module using the enclosed labeling strips.
4. Then insert the labeling strip back into the interface or electronic module.
Figure 6-13 Installing and labeling interface and electronic modules
WARNING
Make sure that the assignment between terminal and electronic module is correct for your
application.
Note
If a gap (of an electronic module) occurs due to the ET 200iSP conguration, the following rules
apply:
• The gap is located at the last slot of the ET 200iSP: Insert the slot cover (or a reserve module)
into this gap.
• The gap is at a dierent slot (for electronic modules): Insert a reserve module into this gap.
Removing interface module and electronic modules
1. Only with IM 152-1PN: Remove the transceiver.
If the transceivers are still plugged in, they could be damaged with the screwdriver.
2. Use the screwdriver to operate the latch on the underside of the interface or electronic
module.
3. Swivel the module upwards.
4. Remove the module from the bearing position of the terminal module.
Wiring
6.5 Inserting and labeling the power supply, interface module, and electronic modules
ET 200iSP
144 Operating Instructions, 11/2022, A5E00247483-AK
To Next Page
Loading...
Need help?
General
