Technical specifications
14.1 Standards, approvals and safety notes
Distributed I/O system
272 System Manual, 09/2019, A5E03576849-AJ
RCM Declaration of conformity for Australia/New Zealand
The ET 200SP distributed I/O system fulfills the requirements of the standards
● EN 61000-6-4.
Korea Certificate KCC-REM-S49-ET200SP
Note that this device corresponds to limit class A in terms of the emission of radio frequency
interference. This device can be used in all areas, except residential areas.
이 기기는 업무용(A급) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시기
바라며 가정 외의 지역에서 사용하는 것을 목적으로 합니다.
Marking for the Eurasian Customs Union
EAC (Eurasian Conformity)
Customs Union of Russia, Belarus and Kazakhstan
Declaration of conformity with the technical requirements of the Customs Union (TR CU).
IEC 61131-2
The ET 200SP distributed I/O system meets the requirements and criteria of the standard
IEC 61131-2 (Programmable logic controllers, part 2: Equipment requirements and tests).
IEC 61010-2-201
The ET 200SP distributed I/O system fulfills the requirements and criteria of IEC 61010-2-
201
(Safety requirements for electrical equipment for measurement, control, and laboratory use
Part 2-201: Particular requirements for control equipment).
IEC 60947
The motor starters belonging to the ET 200SP distributed I/O system meet the requirements
and criteria of the IEC 60947 standard.
PROFINET standard
The PROFINET interfaces of the ET 200SP distributed I/O system are based on IEC 61158
Type 10.
To Next Page
Loading...
Need help?
General
