Siemens SIMATIC ET 200SP System Manual

System overview
3.4 Components
Distributed I/O system
30 System Manual, 09/2019, A5E03576849-AJ
Basic component
Function
Figure
Server module The server module completes the configuration
of the ET 200SP. The server module includes
holders for 3 spare fuses (5 × 20 mm).
The server module ships with the CPU/interface
module.
Coding element The coding element codes the I/O module with
the BaseUnit.
There are two versions:
• Mechanical coding element
①: Ensures the
coding
• Electronic coding element ②: This version
also has an electronic, rewritable memory for
module-specific configuration data (such as
the F-destination address for fail-safe mod-
ules, parameter data for the IO link master).
1)
Note: The description contains non-binding information on supplementary products that are manufactured and marketed
not by Siemens but by third-parties outside the Siemens group ("third-party firms"). These third parties organize the
manufacture, sale and delivery of their products independently and their terms and conditions apply.
Responsibility for these supplementary products and for the information relating to them that is provided here thus lies
solely with the third parties in question. Unless bound to do so by statutory requirements, Siemens shall not accept any
liability or provide any guarantee for the supplementary products of third-party firms. Please also note the information
"Disclaimer/Use of hyperlinks".
2)
Disclaimer/Use of hyperlinks: Siemens has put together this description with great care. However, Siemens is unable to
check whether the data provided by third-party firms is complete, accurate and up to date. Certain items of information
may therefore potentially be incorrect, incomplete or no longer up to date. Siemens shall not accept any liability should
this be the case, nor shall it accept liability for the usability of the data or of the product for the user unless it has a statu-
tory obligation to do so.
This entry contains the addresses of third-party websites. Siemens is not responsible for and shall not be liable for these
websites or their content, as Siemens has not checked the information contained therein and is not responsible for the
content or information they provide. The use of such websites is at the user's own risk.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C