Siemens SIMATIC ET 200SP System Manual

System overview
3.4 Components
Distributed I/O system
System Manual, 09/2019, A5E03576849-AJ
31
Accessories of the ET 200SP distributed I/O system
Table 3- 3 Accessories of the ET 200SP
Accessories
Function
Figure
24 V DC connector Applying the 24 V DC supply at the connector and
connection with the CPU/interface module, for exam-
ple.
Shield connection The shield connection allows the low-impedance
contacting of cable shields with minimum installation
times.
Labeling strips Attach the labeling strips to the modules for system-
specific labeling of the ET 200SP. The labeling strips
can be printed.
The labeling strips can be ordered as accessories
(Page 291
) on a roll for thermal transfer printers or as
DIN A4 format sheets for laser printers.
Reference identification
labels
The labels enable the reference identification labeling
of the ET 200SP components.
The labels can be ordered on a mat for thermal
transfer and inkjet printers as accessories
(Page 291).
Color identification labels The color identification labels are module-specific
and can be ordered for the process terminals, AUX
terminals and additional terminals as accessories
(Page 291).

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C