Siemens SIMATIC ET 200SP - Module Version Selection

System overview
3.4 Components
Distributed I/O system
32 System Manual, 09/2019, A5E03576849-AJ
Accessories of the SIMATIC ET 200SP motor starters
Table 3- 4 SIMATIC ET 200SP motor starter accessories
Accessories
Function
Figure
3DI/LC module The optional 3DI/LC module has three digital inputs and one
LC input. For reasons of operational safety, input LC is per-
manently set to manual local mode. By parameterizing the
inputs DI1 - DI3 with motor CLOCKWISE or motor
COUNTER-CLOCKWISE, you can control the motor in
manual local mode.
The functions of the 3DI/LC module are not relevant to func-
tional safety.
Detailed information on the functions when using a 3DI/LC
module can be found in the Manual
(
https://support.industry.siemens.com/cs/ww/en/view/10947
9973).
Mechanical bracket for
BaseUnit
Use the mechanical bracket for additional fixing of the motor
starter. You can use the mechanical bracket on 7.5 mm and
15 mm mounting rails.
Infeed bus cover For finger-safe termination of the infeed bus, use the cover.
Fan You can use the motor starter at higher ambient tempera-
tures if a fan is installed.