Parameters
4.3 Monitoring functions
SIMOCODE pro - Parameterize
156 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Temperature monitoring (analog)
Schematic and characteristic curve
Temperature monitoring of, for example, motor windings, motor bearings, coolant and
gearbox temperature, can be carried out via up to three analog temperature sensors such as
NTC, KTY 83/84, PT100, PT1000.
SIMOCODE pro supports two-phase monitoring for overtemperature: Separate levels for
warning and tripping temperature can be set.
Temperature monitoring takes into account the highest temperature of all the sensor
measuring circuits of the temperature module.
Figure 4-40 "Temperature Monitoring" function block
To Next Page
Loading...
