Parameters
4.8 Logic modules
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
267
Analog multiplexer
Description
The analog multiplexer (for SIMOCODE pro V PN/pro V EIP basic units only) outputs one of
4 possible analog values at the inputs 1 to 4, depending on control signals S1 and S2.
If you interconnect the input to "Fixed level," the input is assigned the constant "Const x"
(x = 1 ... 4). In this case, the respective edit field for the constant is activated. You can enter
a value between 0 and 65535.
The "Analog Multiplexer" function block consists of:
● two digital plugs (control signal 1 and 2)
● Four analog plugs (Input 1 to 4)
● One analog socket
● Logic.
The following schematic shows the Analog Multiplexer logic module:
Figure 4-113 Analog multiplexer function block
To Next Page
Loading...
