Siemens SIMOCODE pro - Standard Functions; Overview of Standard Functions

Parameters
4.7 Standard functions
SIMOCODE pro - Parameterize
202 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
4.7
Standard functions
4.7.1
Overview of standard functions
Description
So-called "Standard functions" in the form of function blocks are also stored in
SIMOCODE pro, and can be used as required.
These function blocks may contain:
● Plugs
● Sockets in the form of status information
● Setting values, e.g. the response when an external fault occurs ("signal," "warn," or
"tripping").
Schematic
The following schematic shows the general representation of the function block of a standard
function:
Figure 4-75 General representation of the function block of a standard function