Siemens SIMOCODE pro Operating Manual

Parameters
4.7 Standard functions
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
215
4.7.5.2
Response to other control functions
For other control functions, the following scenarios can be differentiated between for OPO:
● Motor in operation: The motor is switched Off with a "Fault - Operational Protection Off
(OPO)" fault.
● The motor is off. Initially no fault. The "Fault - Operational Protection Off (OPO)" fault only
occurs when an "ON command" is issued.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000