Parameters
4.8 Logic modules
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
261
Calculators (calculation modules) 1, 2
Description
The two logic modules "Calculator 1" and "Calculator 2" integrated in SIMOCODE pro V
basic units are capable of the standard calculation modes and enable all analog values
featured in SIMOCODE pro to be adapted, calculated, and converted, for example:
● Conversion of the measured temperatures from K (Kelvin) to °F or °C
● Conversion of the motor current from [%] to [A]
● Conversion of the 0/4 to 20mA signals of the analog module directly into fill levels,
pressures, and flow rates.
The analog value (2 bytes / 1 word) present at the analog sockets is calculated using a
defined formula and using freely-selectable parameters (numerators, denominators,
operators, offsets). The result of the calculation is output as an analog value (2 bytes/1 word)
at the analog socket of the logic module for further processing.
Each calculator consists of:
● one analog plug (Calculator 1) or two analog plugs (Calculator 2)
● one logic component
● one analog socket
The following schematic shows the "Calculators" logic modules:
Figure 4-107 "Calculators" logic modules
To Next Page
Loading...
