Siemens SIMOCODE pro - Operator Panel Leds

Parameters
4.4 Outputs
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
165
4.4.3
Operator panel LEDs
Description
SIMOCODE pro has an "OP LED" function block for controlling the seven freely assignable
LEDs. The LEDs are in the operator panel and can be used to display any status. For this,
the inputs (plugs) of the "OP LED" function block must be connected to the respective
sockets (e.g. to the sockets for the status information of the control function).
Note
The "OP LED"
function block can only be used if the operator panel (OP) is connected and
configured in the device configuration!
The "OP LED" function block consists of:
● Four plugs, "OP LED green 1" to "OP LED green 4," corresponding to the green LEDs.
The green LEDs are optically / mechanically allocated to the buttons on the operator
panel. They normally display feedback concerning the motor operating state.
● Three plugs, "OP LED yellow 1" to "OP LED yellow 3," corresponding to the yellow LEDs.
● Four green LEDs.
● Three yellow LEDs (not for the operator panel with display).
One "OP-LED" function block is available for the SIMOCODE pro C, pro S, pro V,
pro V MB RTU, pro V PN and pro V EtherNet/IP basic units.
LEDs of the operator panel
The following diagram shows the front view of the operator panel and the LEDs:
Figure 4-46 LEDs of the operator panel