Parameters
4.4 Outputs
SIMOCODE pro - Parameterize
180 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
In addition to "Cyclic Send," it is possible to transfer a further 16 bits of binary information via
OPC UA.
With the "OPC UA Send" function block, you can specify which information is to be
transferred. The inputs (plugs) of the function blocks must be connected to the respective
sockets.
The "OPC-UA send" function blocks each consist of eight bits (= two bytes, byte 0 and byte 1
for binary information).
A total of two "OPC-UA Send" function blocks are available.
The following schematic shows the "OPC-UA Send" function blocks:
Figure 4-58 "OPC-UA send" function blocks
Table 4- 57 OPC-UA Send Data settings
Bytes 0 to 1, bits 0 to 7 Setting and resetting of bits by means of any signal (any socket, e.g.
device inputs, send data, status information, events, etc.)
To Next Page
Loading...
