Siemens SIMOCODE pro - Signal Conditioner

Parameters
4.8 Logic modules
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
247
4.8.7
Signal conditioner
Description
If an input signal is pending, the signal conditioning issues an output signal according to the
selected signal conditioning type:
● Non-inverting
● Inverting
● Edge rising with memory
● Edge falling with memory
You can set the output response.
The signal conditioning consists of:
● two plugs (input and reset)
● one logic component
● one socket
The following are available:
● two signal conditionings (1 to 2) for the SIMOCODE pro C basic unit
● four signal conditionings (1 to 4) for the SIMOCODE pro S, pro V PB and pro V MB RTU
basic units
● six signal conditionings (1 to 6) for the SIMOCODE pro V PN and pro V EIP basic units.