Parameters
4.5 Inputs
SIMOCODE pro - Parameterize
188 Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
Digital module inputs
Description
SIMOCODE pro has two "DM Inputs" function blocks, each with 4 binary inputs connected to
common potential. You can connect, for example, the buttons for a local control station to the
inputs. These signals can be further processed in SIMOCODE pro by internally connecting
the sockets of the "DM Inputs" function blocks.
Note
"DM Inputs" function blocks can only be used if the corresponding digital modules (DM) or a
multifunction module
(MM) are connected and configured in the device configuration!
Each "DM Inputs" function block consists of:
● Input terminals located on the outside of the digital module, corresponding to the
sockets "DM Input 1" to "DM Input 4"
● Sockets in SIMOCODE pro that can be connected to any plugs, e.g. to the "Control
Stations" function block.
The following are available:
● A function block "DM1 Inputs" on the SIMOCODE pro S multifunction module
● Two function blocks "DM1 inputs" and "DM2 inputs" on the SIMOCODE pro V basic unit.
To Next Page
Loading...
