Siemens SIMOCODE pro Operating Manual

Parameters
4.7 Standard functions
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
221
Schematic
The following schematic shows the "Safety-related tripping" function block:
Figure 4-83 "Safe Tripping" function block
SET / RESET button on DM-F Local
Figure 4-84 SET / RESET button
See ManualSIMOCODE pro Safety fail-safe digital modules
(http://support.automation.siemens.com/WW/view/en/50564852).
DANGER
Automatic starting after power failure. Risk of death or serious injury.
In the case of automatic starting after a power failure, the enabling circuits are connected
without pressing the Start button.

Siemens SIMOCODE pro Specifications

General

Protection Class	IP20
Mounting Type	DIN rail mounting
Rated Operational Voltage	24 V DC
Rated Current	Up to 820 A
Protection Functions	Overload, short-circuit, phase failure, asymmetry, ground fault, motor stall
Operating Temperature Range	-25°C to +60°C
Communication Protocols	PROFIBUS DP, PROFINET, Modbus RTU
Analog Outputs	Up to 2
Temperature Monitoring	PTC/KTY, RTD (PT100/PT1000)
Digital Outputs	Relay outputs, Solid-state outputs
Analog Inputs	0/4-20mA, PT100/PT1000