Parameters
4.8 Logic modules
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
243
The following schematic shows the "Timers" logic modules:
Figure 4-96 "Timer" logic modules
Note
The output is always 0 if a reset is pending.
Note
The response of the plugs of all timers (input, reset) has been completely changed to level
-
pro C basic unit from version *E05* and higher and the
pro V PB basic unit from version *E03* and higher. Use of an unchanged
parameter file utilizing integrated timers may thus result in a different response if such basic
units are used. For example, if "Fixed level
- '1'" is set at the timer input, the timer function is
ically restarted after the timer reset occurs. However, in timers with the
parameterized type = "Fleeting closing" there is no change in the response.
To Next Page
Loading...
