Siemens SIMOCODE pro - Page 51

Parameters
4.1 Motor protection
SIMOCODE pro - Parameterize
Operating Manual, 04/2017, A5E40507630002A/RS-AA/001
51
Response
● Overtemperature:
Here you can select the SIMOCODE pro response to violation of the trip level for
overtemperature.
Note
With motors for EEx e applications, the response must be set to "tripping"!
● Sensor fault (sensor circuit fault): Here you can select the SIMOCODE pro response in
the case of a short circuit or open circuit in the thermistor sensor cable.
Table 4- 3 "Thermistor protection, binary" response
Response
Trip level
Sensor fault
disabled — X
signal
X
X
warn
X
X (d)
tripping
X (d)
X
See also "Tables of responses of SIMOCODE pro" in Chapter Important information
(Page 7).