Siemens SIMODRIVE 611 universal - Index

E
E-915
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Index
Symbols
! 611ue diff !, vi, 1-55
! not 611u !, vi, 1-55
! not 611ue !, vi, 1-55
Numbers
1FE1 motors, 4-153, A-865
1FK6 motors, A-859
1FNx motors, A-873
1FT6 motors, A-859
1FW6 motors, A-871
1PHx motors, A-878
2SP1 motors, A-865
A
Abbreviations, B-891
Acknowledging faults, 7-621
with POWER ON, 7-621
with RESET FAULT MEMORY, 7-621
Actual position value, 6-381
Address
Documentation (Fax, email), v
Internet, v
Technical Support, v
Adjusting
Absolute value encoders, 6-399
Reference cams, 6-392
Alarms, 7-620
Displaying, 7-624
Handling the, 7-625
List of, 7-628
Overview of the, 7-620
Parameterizable, 7-623
Stop responses of, 7-622
Analog inputs, 2-76, 6-528
Analog outputs, 2-75, 6-542
Analog signals
for the current and speed control loop,
6-552
for the position control loop, 6-553
Angular incremental encoder interface, 2-77,
6-556
as an output, 6-558
as input (from SW 3.3), 6-563, 6-567
Handwheel connection, 6-567
Terminating resistor, 1-39
Any gearbox ratio (from SW 8.1), 6-357
Automatic controller setting, 6-336
Automatic power module identification,
4-137
Axis couplings (from SW 3.3), 6-431
Equalization controller (from SW 7.1),
6-467
Torque setpoint coupling via PROFIBUS
(from SW 4.1), 6-461
with queue function (being prepared),
6-446
B
Backlash compensation, 6-376
Ballscrew, 6-354
Basic commissioning, 3-102
Block change enable, 6-416
CONTINUE EXTERNAL (from SW 3.1),
6-419
CONTINUE FLYING, 6-418
CONTINUE WITH STOP, 6-418
END, 6-417
Boot, 3-99, 4-132
Brake sequence control, 6-570
Build-in torque motors, 4-165, A-871
C
Cable, recommended, 2-68
Cable diagram
for RS232, 2-85
for RS485, 2-86
Calculate controller data, 4-132
E