Siemens SIMODRIVE 611 universal - Page 918

E
E-918
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Engineering
the drive group, 1-28
the process data (from SW 3.1), 5-255
Equipment bus, 2-70, 2-74
Equivalent zero mark, 6-403, 6-493
ESDS information and instructions, xv
ESDS measures, 2-66
Establish the status when originally shipped
(from SW 3.1), 3-99, 4-131
Expert list, 3-101
Explanation of symbols, xii
External block change (from SW 3.1), 6-419
F
FAULT LED, 1-38, 7-627
Fault without a number being displayed,
7-628
Faults, 7-620
Acknowledging, 7-621
Can be set (from SW 3.3), 7-623
Evaluating via PROFIBUS-DP, 5-290
Handling the, 7-625
List of, 7-628
Overview of the, 7-620
Stop responses of, 7-622
that can be suppressed, 7-623
FEPROM: Save data, 4-131
Fixed endstop (from SW 3.3), 6-594
Fixed setpoint (from SW 3.1), 6-340
Fixed speed setpoint (from SW 3.1), 6-340
Following error monitoring, 6-382
Function generator, 7-714
Function overview, 1-27
Function–initiating parameters, 4-131
G
GSD, 5-281
H
Hardware
limit switch (n-set mode), 6-345
limit switch (pos mode), 6-371
parameterizing, 4-137
Hardware limit switch
n-set mode, 6-345
pos mode, 6-371
Help for the reader, vii
Holding brake, 6-570
Hotline, v
I
i2t power module limiting (from SW 3.1),
A-857
IM operation, 4-141
Image
Input signals, 4-136
Input terminals, 4-136
Output signals, 4-136
Output terminals, 4-136
Indirect measuring system, A-889
Input signal, analog, 6-528
Input signal, digital
Acceleration time zero for controller
enable (from SW 3.1), 6-497
Activate angular incremental encoder,
handwheel (from SW 8.1), 6-495
Activate function generator (edge) (from
SW 8.1), 6-497
Activate MDI (from SW 7.1), 6-495
Activate teach–in (from SW 4.1), 6-488
Activate the coupling via I0.x (from SW
3.3), 6-492
Activate traversing task (edge), 6-486
Activates coupling (from SW 3.3), 6-491
Angular incremental encoder handwheel
evaluation, bit 0 (from SW 8.1), 6-495
Angular incremental encoder handwheel
evaluation, bit 1 (from SW 8.1), 6-495
Block selection, 6-484
Control requested/no control re-
E Index
04.05