Siemens SIMODRIVE 611 universal - Page 919

E
E-919
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
quested, 6-488
Enable inverter/pulse inhibit, 6-482
Enable setpoint/inhibit setpoint, 6-495
Equivalent zero mark, 6-493
External block change (from SW 3.1),
6-489
First speed setpoint filter off, 6-480
Fixed end stop, sensor (from SW 3.3),
6-490
Fixed speed setpoint (from SW 3.1),
6-480
Flying measurement (from SW 3.1),
6-494
Inactive, 6-478
Incremental jogging (from SW 4.1), 6-487
Integrator inhibit, speed controller, 6-479
Invert the angular incremental encoder
input (from SW 3.5), 6-493
Jogging 1 ON/jogging 1 OFF, 6-487
Jogging 2 ON/jogging 2 OFF, 6-487
Master sign–of–life (from SW 3.1), 6-497
Minus hardware limit switch (NC con-
tact), 6-494
Motor changed over (from SW 2.4),
6-496
Motor data set changeover (from SW
2.4), 6-478
ON/OFF 1, 6-481
Open–loop torque controlled mode,
6-478
Opening the holding brake for test purpo-
ses (from SW 4.1), 6-483
Operating condition/intermediate stop,
6-485
Operating condition/OFF 2, 6-481
Operating condition/OFF 3, 6-482
Operating condition/reject traversing
task, 6-484
Parameter set changeover, 6-479
Plus hardware limit switch (NC contact),
6-494
Ramp–function generator enabled, 6-482
Ramp–function generator start/ramp–
function generator stop, 6-495
Ramp–up time zero, 6-479
Reference cams, 6-493
Request passive referencing (from SW
5.1), 6-490
Reset the fault memory, 6-478
Selection, parking axis, 6-483
Set reference point, 6-491
Setpoint setting, master drive (from SW
4.1), 6-492
Spindle positioning on (from SW 5.1),
6-481
Start referencing/cancel referencing,
6-488
Suppress fault 608 (from SW 3.1), 6-481
Tracking operation, 6-490
Input terminals
Assignment, for the optional TERMINAL
module (from SW 4.1), 6-527
Delay time, 2-76
for control board, 6-474
for the optional TERMINAL module,
6-526
Freely parameterizable, 6-474, 6-526
Open, 2-76, 2-79
Permanently–connected, 6-473
Installation and mounting
an option module, 2-61
new control boards, 2-63
of the control board, 2-60
the memory module, 2-62
Integrated help, 3-103
Interface converter, 3-106
Interfaces, 1-24, 2-71
Internet address, v
Inversion
Actual position value, 6-381
Output terminal signals, 6-499, 6-527
Position setpoint, 6-381
Reference cam signal, 6-391
Speed actual value, 6-332
Speed setpoint via terminals, 6-532
J
Jerk limiting (from SW 3.1), 6-368
Jog
incremental (from SW 4.1), 6-406
via velocity, 6-406
K
Key combinations, operator unit, 3-93
Kv factor, 6-378
L
Leadscrew pitch, 6-354
E Index
04.05