Siemens SIMODRIVE 611 universal - Page 920

E
E-920
 Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
LED
on the control board, 1-38, 7-627
on the optional PROFIBUS-DP module,
1-41, 5-289
Limit switch monitoring functions, 6-371
Limits
Current limit, 6-351
Speed limiting, 6-346
Speed setpoint, 6-346
Torque, 6-348
Linear motors, 4-169
List
of abbreviations, B-891
of encoders, A-885
of faults and warnings, 7-628
of induction motors, A-878
of linear synchronous motors, A-873
of parameters, A-732
of permanent–magnet synchronous mo-
tors with field weakening (1FE1),
A-865
of references, C-897
of rotating synchronous motors, A-859
of the input signals, 6-478
of the output signals, 6-504
of the permanent–magnet synchronous
motors without field weakening
(1FW6), A-871
of the power modules, A-856
M
Master control, 3-101
Master device file (GSD), 5-281
Master/slave, 6-462, 6-540
MDI operation (from SW 7.1), 6-426
Measurement function, 3-99, 7-726
Memory module, 1-26, 2-62
Mini connector, 2-67
Monitoring functions, 6-341
Monitoring when positioning
Dynamic monitoring of following errors,
6-382
Positioning monitoring, 6-385
Standstill monitoring (zero–speed moni-
toring), 6-383
Motor, 1-25, A-859
Motor changeover (from SW 2.4), 6-580
Motor code, 4-138
for linear synchronous motors, A-873
for permanent–magnet synchronous mo-
tors with field weakening (1FE1),
A-865
for permanent–magnet synchronous mo-
tors without field weakening (1FW6),
A-871
for rotating induction motors, A-878
for rotating synchronous motors, A-859
Motor connection, 2-70
Motor data optimization, 4-134, 4-148
motor data set, 6-581
Motor holding brake, 6-570
Motor temperature, 6-341
MSR, 6-361, 6-365
N
New information
for SW 2.4, viii
for SW 3.1/3.2, viii
for SW 3.3, ix
for SW 4.1, ix
for SW 5.1, x
for SW 6.1, x
for SW 7.1, x
for SW 8.1, x
for SW 8.3, xi
Identification of, vii
Notes
Hotline, v
Technical Support, v
O
Open input, 2-76, 2-79
Open–loop torque controlled mode, 6-534
Opening the holding brake for test purposes
(from SW 4.1), 6-483
Operating display (status), 4-135
Operating mode, 1-24, 4-139
Positioning (from SW 2.1), 6-353
Speed/torque setpoint, 6-331
Operator unit, 1-38
E Index
04.05