Siemens SINAMICS S110 - Interface description

CU305 Control Units
7.3 Interface description
SINAMICS S110
132 Manual, 07/2015, 6SL3097-4AC10-0BP5
Note
Function equipotential bonding for distributed DRIVE-CLiQ nodes
Integrate all of the components that are connected via
DRIVE-CLiQ into the function
equipotential bonding concept. The connection should be preferably established by mounting
on metallic bright machine and plant components that are connected with one another using
an equipotential bonding conductor.
Alternati
vely, you can establish equipotential bonding using a conductor (min. 6 mm²), which
as far as possible, is routed parallel to the DRIVE
-CLiQ cable.
This applies to all distributed DRIVE
-CLiQ nodes such as DME20, SME2x, SME12x, etc.
7.3
Interface description
7.3.1
General interface overview
Table 7- 2 Interface overview classified according to terminal
Terminal
CU305 PN
CU305 DP
CU305 CAN
Specific interfaces
X150 P1 / X150 P2
PROFINET
-
-
X126
-
PROFIBUS
CAN
Identical interfaces
X100
DRIVE-CLiQ
X124
Electronics power supply
X130
Fail-safe digital inputs
X131
Fail-safe digital inputs/outputs
X132
Digital inputs/outputs, analog input
X133
Digital inputs, temperature sensor input
X23
Encoder interface (HTL/TTL/SSI)
X22
Serial interface (RS232)
X520 / X521 / X522
Measuring sockets