Siemens SINAMICS S110 - DRIVE-CLiQ coupling

Accessories
9.2 DRIVE-CLiQ coupling
SINAMICS S110
220 Manual, 07/2015, 6SL3097-4AC10-0BP5
9.2
DRIVE-CLiQ coupling
9.2.1
Description
The DRIVE-CLiQ coupling is used to connect 2 DRIVE-CLiQ cables in accordance with
degree of protection IP67 acc. to EN 60529.
In addition to the data lines, the power supply contacts of DRIVE-CLiQ are also routed via
the coupling.
9.2.2
Safety Information
NOTICE
Damage caused by the use of incorrect DRIVE-CLiQ cables
The use of incorrect or not released DRIVE-CLiQ cables can cause damage or functional
faults to devices or the system.
• Use only appropriate DRIVE-CLiQ cables that have been approved by Siemens for the
use case in question.
9.2.3
Interface description
9.2.3.1
Overview
①
Rating plate
②
Protective cap, Yamaichi, Article No.: Y-ConAS-24-S
Figure 9-10 Interface overview, DRIVE-CLiQ coupling