Siemens SINAMICS S110 - X150 P1; P2 Profinet

CU305 Control Units
7.3 Interface description
SINAMICS S110
134 Manual, 07/2015, 6SL3097-4AC10-0BP5
Note
The address switches, which are located beneath the cover for the Basic Operator Panel
BOP, have no function for th
e CU305 PN.
7.3.2.2
X150 P1 / P2 PROFINET
Table 7- 3 X150 P1 and X150 P2 PROFINET
Pin
Signal name
Technical data
1
RXP
Receive data +
2
RXN
Receive data -
3
TXP
Transmit data +
4
Reserved, do not use
-
5
Reserved, do not use
-
6
TXN
Transmit data -
7
Reserved, do not use
-
8
Reserved, do not use
-
Connector type:
RJ45 socket
Data rate:
100 Mbits or 10 Mbits
Note
The PROFINET interfaces support Auto MDI(X). It is therefore possible to use both crossed
and uncrossed cables to connect the devices.
There are four LEDs on the front panel of the CU305 PN to display status information about
the PROFINET interfaces (see Interface overview (Page 133)).
The table shows the status information these indicate.
Table 7- 4 LED states on the X150 P1/P2 PROFINET interface
LED
Color
Status
Description
LNKx - Off Missing or faulty link
Green
Flashing light 0.5 Hz
Connection establishment
Continuous light
10 or 100 Mbit link available
ACTx
-
Off
No activity
Yellow
Flashing light
Data is being received or sent at port x