Commissioning Manual
01/2017
149
Go to the Web License Manager (
http://www.siemens.com/automation/license) on a comput-
er with Internet access, and login via "Direct access".
Follow the instructions in the Web License Manager to assign the licenses of your purchased
options to the specifi
ed PPU. A license key is generated after the licenses are assigned suc-
Enter the license key generated by the Web License Manager in the following dialog box:
Press this softkey to confirm your entry.
Press this softkey to open the window of available options. You can find the l
icensing status
in this window, for example:
If you have licensed one or two additional axes, you can find "1" or "2" in the column of l
i-
censing status. For other licensed options, a "☑" symbol displays in this column.
The last option (see below) in this window indicates the variant information and the
licensing status of your control system, for example:
In case of any problems with the licensing status of your control system, contact Siemens
service personnel.
Set the licensed options.
For the additional axes, enter "1" or "2" in the setting column and press the following key:
Note that for the milling variant, you can only enter "1" because a maximum of one
additional axis is supported on a milling machine.
For the other options, press the following key to select:
To Next Page
Loading...
Need help?
General
