Siemens SINUMERIK 808D ADVANCED

Commissioning Manual
148 01/2017
9.
Press this softkey to confirm the archive infor
mation, and then the following message appears:
10.
Press this softkey to confirm and start loading the
archive. The control system restarts to com-
plete restoring the system language archive.
11.
Power off/on the control system to activate the loaded language. Then you can find the new
system language and select it th
rough the following operations:
+ →
5.6
Activating the optional functions
The following optional functions can be purchased for the control system:
● Additional axes
● Contour handwheel
● Bidirectional leadscrew error compensation
● Manual Machine Plus (for the turning variant of the control system only)
● Transmit/Tracyl
● Gantry (BASIC)
● CNC lock
Note
Before activating the Manual Machine Plus function, make sure that MD20050 is set to default.
Note
The co
ntrol system with PPU161.3/PPU160.2 supports up to two additional axes for the turning variant and one for the
milling variant. The control system with PPU141.2 supports one additional axis for the turning variant only.
To use a purchased option, you must first activate it with a license key on the control system. After you purchase the desired
option(s), you can obtain the corresponding license key from the Web License Manager.
Operating sequence
+
1.
Select the system data operating area.
2.
Press this key to view the extended softkeys.
3.
Open the dialog box for entering the license key through the following softkey op
erations:
→ →
Then you can find the serial number of the CF card in the following dialog box: