Siemens SINUMERIK 808D ADVANCED Commissioning Manual

Commissioning Manual
01/2017
431
17
PLC user interface
17.1
Signals from/to the MCP
Horizontal MCP with override switches
The figure below takes the horizontal MCP variant with override switches as an example. The vertical MCP variants share
the same PLC interface addresses for the corresponding keys.
Note that labels K13, K15, K19, and K21 are not included in the pre-inserted labeling strips for keys of the MCP. The figure
includes these labels so that when you read the information in the following two tables, you know which keys on the MCP it
refers to.
From the MCP
DB1000
From the MCP [r]
Byte
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
0 M01 PROGRAM
TEST
MDA SINGLE
BLOCK
AUTO REF. POIN
T
JOG HAND
WHEEL
1 Key 7 TAIL
STOCK
INT. EXT. CHUCK TOOL
CHANGE
COOLANT LAMP ROV
2
100 (INC)
10 (INC)
1 (INC)
Key 12
Key 11
Key 10
Key 9
Key 8
3 Axis trav-
ersing key
(↑x)
Key 13 CYCLE
START
CYCLE
STOP
RESET SPINDLE
RIGHT
SPINDLE
STOP
SPINDLE
LEFT
4 Key 21 Axis trav-
ersing key
(↓x)
Key 19 Axis trav-
ersing key
(→z)
RAPID Axis trav-
ersing key
(←z)
Key 15
8 Feed override value (in Gray code)
9
Spindle override value (in Gray code)
To the MCP
DB1100
To the MCP [r/w]
Byte
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
0 M01 PROGRAM
TEST
MDA SINGLE
BLOCK
AUTO REF.
POINT
JOG HAND
WHEEL
1 Key 7 TAIL
STOCK
INT. EXT. CHUCK TOOL
CHANGE
COOLANT LAMP ROV
2
100 (INC)
10 (INC)
1 (INC)
Key 12
Key 11
Key 10
Key 9
Key 8

Siemens SINUMERIK 808D ADVANCED Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED
Category	Control Unit
Language	English