Commissioning Manual
28 01/2017
MOTION-CONNECT 300 power cable
(V70 FSB/FSC to 1FL6)
MOTION-CONNECT 300 brake cable
MOTION-CONNECT 300 incremental
encoder cable
MOTION-CONNECT 300 absolute
encoder cable
SINAMICS V70 spindle drive to 1PH1 motor
MOTION-CONNECT 500 power cable
(4 × 2.5 mm
2
, raw cable), for 1PH1
MOTION-CONNECT 500 power cable
(4 × 4 mm
2
, raw cable), for 1PH1
MOTION-CONNECT 500 power cable
(4 × 10 mm
2
, raw cable), for 1PH1
MOTION-CONNECT 500 power cable
(4 × 16 mm
2
, raw cable), for 1PH1
MOTION-CONNECT 300 incremental
encoder cable
The MOTION-CONNECT 300 cables, MOTION-CONNECT 500 cables, and spindle setpoint cables given above are
suitable for use in drag chains. For more information on how to lay cables properly in drag chains, see Section "
the laying of cables in drag chains (Page 79)".
No additional MOTION-CONNECT 300 power cables are available for 1PH1 motors. The 30 m MOTION-
power cables (raw cables) listed above could be selected for using with 1PH1 motors. You must assemble the power
cable with connectors by yourself. For more information about how to assemble the power cable, see Section
"Assembling the power cable for the 1PH1 motor (Page 480)".
To Next Page
Loading...
Need help?
General
