Siemens SINUMERIK 808D ADVANCED

Commissioning Manual
304 01/2017
Tag identifier
Meaning
CREATE_CYCLE_EVENT
If the parser starts to process the tag CREATE_CYCLE, initially, the message
<CREATE_CYCLE_EVENT> is sent to the active form. This message can be used for
preparing the cycle parameters, before the parser generates the NC operation from the
parameter list and the generation rule.
Syntax:
<CREATE_CYCLE_EVENT>
…
…
</CREATE_CYCLE_EVENT>
Example:
<SOFTKEY_OK>
…
<CREATE_CYCLE />
…
…
<SOFTKEY_OK>
…
…
<FORM>
<NC_INSTRUCTION>MY_CYCLE($P1, $P2)</ NC_INSTRUCTION >
…
…
<CREATE_CYCLE_EVENT>
<type_cast name="P1" type="int"/>
<OP> P1 = P1 * 150 </OP>
</CREATE_CYCLE_EVENT>
…
…
</FORM>