Commissioning Manual
01/2017
33
●
The figure below provides a connection example. It shows how to connect a line filter to a SINAMICS V70 drive.
Max. tightening torque (Nm)
Cross head (M4 screw) 1.5 8
Slot head (M4 screw)
Inside hexagon (M6 screw)
An SD card can be used to copy drive parameters or perform a firmware update. Siemens recommends you to use the
Siemens SD card (article number: 6SL3054-4AG00-2AA0).
You can also select other high quality SD cards with a maximum capacity of 2 GB from manufacturers such as KINGMAX,
Kingston or SanDisk, which are not tested by Siemens.
The Toolbox DVD (article number: 6FC5811-0CY00-0YA8) provides necessary software tools to integrate the control system
into a machine tool. Under the Toolbox DVD root directory, it contains a file "setup.exe". After starting this file the program
guides you through installing the following software on the computer:
● SinuComPCIN (PPU160.2 only)
– SinuComPCIN is a tool that allows the commissioning engineer to exchange files between the computer and the
control through RS232 interface.
To Next Page
Loading...
