Commissioning Manual
46 01/2017
Enter the IP address for the control system that displays in the above link setup dialog box
in the communication settin
gs dialog box.
-click this symbol in the communication setting window to establish a connection to
the specified IP address.
Wait until the information of the connected control system is identified as follows, and then
the connection is ready.
Establishing a network connection
Proceed through the following steps to establish a network connection:
Connect the control system with the local network using an Ethernet cable.
Select the system data operating area on the PPU.
Press this key to view the extended softkeys.
een of the service control options through the following softkey opera-
Press this softkey to enter the window for the network configuration.
Make sure the following vertical softkey is deactivated:
he network as required in the following window:
can configure DHCP with the following key:
If
you select "No" for DHCP, you must enter the IP address (which must belong to the
same network as that of your computer) and subnet mask manually.
Press this softkey to save the configuration. If you select "Yes" for DHCP, you also need to
restart the control system to activate the network configuration
.
To Next Page
Loading...
Need help?
General
